Demoing Out A Balcony To Build A Deck: a house log

Deck plans completed? Check. Permit acquired? Check. Materials scheduled to arrive this week? Check. But one thing still stands in the way of this project moving forward: the old rotting balcony.

We attacked this assignment quite methodically. I laid out a bunch of tools (crowbar, sledgehammer, power drill). I lugged over my ladder (for straightforward climbing up and over the side). I had music playing (see the ceramic pig on the windowsill?). I had Sherry on standby (she was inside watching Clara but ready to lend a hand/take pics at a moments notice). You know, the works. I figured it’d be a quite careful process of prying off boards and observing how this previous structure was created, so that I might learn something for my new deck.
Well, methodical swiftly went out the window and my demo “technique” rapidly turned into this:

So I fairly much simply pulled and pushed back and forth on the railing until the whole outside edge of the balcony began to twist off from the two ledger boards affixed to either side of the house (so it was not scratching the house, simply grinding against those ledger boards flanking each side that I’d also be removing).

Before long, the whole thing had flipped over and fully pulled off the house. What you see below is the underside of the balcony floor (the top of the railing has twisted over to be on the ground).

Once the bulk of the structure was out of the way (which took all of 15 minutes – no tools required), my task turned to removing the various boards that had attached it to the house.

There was this ledger board that was bolted into the brick on one side…

…and this other one that seemed to be simply nailed into the siding. From what I have been reading, this is not recommended. For one, you are apparently supposed to remove any siding that is in the way so you can attach the ledger boards directly to the home’s rim board. If I am losing you on any of these terms, this is a helpful chart that has helped me keep things straight.

The other thing that I will do differently is install some metal flashing to assist keep water from rotting away at the house. This previous installation did not have that, so the board and the piece of wood siding were both fairly rotted. But I was able to clear both away…

… to expose the rim board of the house.
Thankfully the new deck will run where that whole bottom strip of wood siding lives (the part that is good and not rotted to the left of the part above), so it will be coming out. Which means I can reuse it for some of the rotten part above the missing siding strip that you see here. In other words, we will be reusing good wood siding that needs to come out anyway. And we will be adding metal flashing this time- so none of that nasty rot will plague us again.
Oh, and here is the progress shot that we shared on Thursday.

This is me tapping the joist loose that sat closest to the house (the other joist came down with the railing). It simply sat in the metal hangar, so all it took was a light nudge with the rubber mallet to get it out. No giant sledgehammer required (darn).
In order to remove the ledger board from the house, I broke out my wrench to loosen the hex nuts that kept it screwed tightly into the brick. You can see here that flashing was not used and that this board too has seen better days.

Once I got it took out, you can see the bolts that are still set in the brick. I am leaving those in for now. If I cannot reuse them, at least perhaps I can get some pointers for my new bolts by removing them once all of my materials have arrived.

But anyways, by this point the whole balcony was officially gone. Well, in fact it is officially sitting in a trash pile behind where I stood to take this picture. But we are not thinking about that yet. Let us simply focus on the progress for now. That and our sliding door to nowhere.

I am a bit anxious / excited to in fact start construction. Materials should all be here within the next few days and I have got my dad scheduled to come assist us get began later in the week. He built the deck on the house that I grew up in, so we thought it’d be helpful to have him around. Hope he does not mind that we demoed without him! So by this time next week we should at least have sufficient going on back there to report back to you folks. We wish we could say we will be back with wrapped up deck pics in three days – but HGTV, we are not. Haha. We will certainly be tackling this project in stages – likely over the next few weeks. But you know we will keep you posted! And hopefully by sharing each stage of the process with pics and details it might assist other folks out there who are planning to dive into deck-building someday.
Has anyone else demolished something lately? Or do you have a strong demolition story? Were you ever surprised by how something was constructed – like a deck floor that flips up when you tug on the railing or rotten wood due to missing flashing?







