A Swift Way To Hang Curtain Rods

Here is a plain trick we used to hang curtain rods FAST and EVELY in our duplex rental. We had 16 curtain rods to hang in one afternoon, so we devised a plain & free way to minimize measuring, while keeping everything looking level and equally spaced. This should take a lot of the headache out of hanging new curtains, especially if you are doing more than one window in your room. Plus, the trick is totally free!

For this installation, we are using affordable curtain rods like these that you can get at most big box stores and these ring clips. We also are hanging plain $14 white Ikea curtain panels using this trick for making Ikea curtains look pricey. Together, these pointers saved us hundreds of dollars across the whole house!

Before we talk about HOW to install your curtain rods, let us talk about exactly WHERE to put them. Here is some swift curtain basics:

How HIGH Should You Hang Curtain Rods?

There is no firm rule for this, but most people agree that curtains look best when they are hung (say it with me!) HIGH AND WIDE. As in, higher and wider than the window itself. This not only creates the illusion of a bigger, grander window, but it also makes your room feel taller and draws the eye up. The below has 9ft ceilings, and you can see how pleasant it is for the window trim to get to breathe a little, and for the eye to follow the curtains from floor to nearly-ceiling.

Speaking of the floor, most experts say that your curtains should typically touch or nearly touch the floor itself. Some like them to hover slightly above the ground, others enjoy a dramatic pool of fabric at the bottom. We typically like them to graze the floor ever so slightly – like below in our showhouse’s dining room. We find this helps keep them in place better.

The precise placement of your rod depends on a few factors (ceiling height, curtain length, trim & molding style, etc) so I cannot give you a hard and fast measurement for where your rod should consistently go… but generally, we like to hang ours about 3-4″ below the ceiling or, if there is crown molding, 3-4″ below the bottom edge of the crown. This allows the curtain rod to “reside” fully (including finials) within the painted area between the window and the ceiling.

But the essential thing to note is that we are hanging them in relation to the ceiling, NOT the window. It is the assumption that your curtains need to relate to the window that causes a lot of people to hang their curtains too low.

That being said, sometimes the window trim is truly close to the crown or ceiling and you may not have 3-4″ inches of space to work with, like you can see in the photo below.

Also, any especially tall rooms or spaces with sloped ceilings are special cases where you will have to make a judgment call and you may not be able to determine your curtain rod height in relation to the ceiling.

Ultimately, our go-to way to confirm the ideal curtain height is to hold half of the rod up and have someone else step back to double-check that it looks good. You can do this with simply one curtain panel attached (after you’ve washed, ironed, and done whatever else might change the height of your panel – except for hemming, that should happen once they are hung so you can get the ideal length).

How WIDE Should You Hang Curtains?

This also depends on several factors, like the window size, what else is on the wall (especially if there are OTHER windows nearby), and how tight or loose you want your panels to look. Generally, we like to place the rod hooks about 8-11″ from the outer edge of the window trim.

By barely covering the edges of the windows you create the illusion that the windows are wider than they truly are. In other words: THE CURTAIN PANELS ARE HANGING IN FRONT OF THE WALL NEXT TO THE WINDOW – NOT IN FRONT OF THE WINDOW (which makes it look smaller and blocks light). Sorry for shouting, but it makes such an crazy good difference.

If the two windows are closer together (like in our bedroom below) you may have to cheat your rod closer than that 8-11″ distance from the window trim. Conversely, we might hang the curtains even wider if we are trying to fill a large wall space.

You can even hang the rod wider on one side than the other if we are trying to make a window look less off-center (more on that here – it can make all the difference!). So it truly is flexible.

Our Straightforward Curtain Hanging Trick (On Video)

Knowing the width (your desired distance from the window trim) and height (your desired distance from the ceiling) is what makes this straightforward trick possible. John demonstrates it all in this video below (also watch for my especially cool footwear cameo). There are more photos after the video, but I’d strongly recommend coming back to view it when you can.

NOTE: You can also watch it here on YouTube.

Tools & Materials Needed

Apart from your curtain rod and the included hanging hardware (brackets, screws, wall anchors), there are quite few items you will need to hang it swiftly:

• Power drill
• Small drill bit (like 3/32″) to make pilot holes
• Larger drill bit (like 3/16″) to make wall anchor hole
• Tape measure or ruler
• Pen or pencil
• Scrap cardboard sheet (like the one that came with your curtain panels)
• Stool or stepladder

How to Hang Curtain Rods

Here is a swift overview of the steps we will cover:

1. Determine measurements
2. Make a cardboard template
3. Drill pilot holes
4. Drill larger holes & add anchors
5. Install curtain brackets
6. Add rod & curtain panels

Step 1: Determine Your Measurements

We held up one curtain panel on the rod to finalize what spot looked best and then held the curtain rod bracket in place to take measurements. Using a tape measure, we determined that we hoped to place our curtain rods 10.5″ from the outside of the window frame (weirdly specific, I know) and 3″ down from the ceiling. These are our measurements to the top screw hole in the rod bracket since we find it easiest to work with the measurements of where you will in fact need to drill.

Step 2: Make A Cardboard Template

We used a scrap piece of cardboard to make our template – marking 10.5″ from both sides (see white arrows) and 3″ down from the top (yellow area). This was in fact the cardboard that came in the curtain package, so you might have something like it on hand already! Once we marked our lines, we lined up the curtain rod hook and marked the two screw holes on BOTH 10.5″ marks.

Step 3. Drill Pilot Holes

Load up your power drill with a small pilot hole bit (we used a 3/32″ bit) and hold your template above your window with the top edge flush to the ceiling and the side edge lined up with the outside edge of the window frame. Then you can simply drill small pilot holes through your two template marks.

A note about keeping things level: CEILINGS ARE NOT Consistently LEVEL (I am looking at you, duplex) so using the ceiling as your guide might seem ill-advised.

Swift Pointer: Dealing With Sloped Ceilings

Got sloped ceilings? Do not panic! When you are hanging the rod close to your ceiling, you in fact want the rod to follow any slope in the ceiling! It will be your eyes’ closest reference point for a straight line, so it will likely appear level even if it is not. That is why a level is not required for this process.

In fact, putting a perfectly level curtain rod next to a sloped ceiling could in fact make the rod look wrong. Or emphasize that the ceiling is wrong. So yeah, using the ceiling as your guide in fact works well for wonky ceilings (again, the duplex has plenty of those).

Step 4. Drill Larger Holes & Add Anchors

Once you’ve made pilot holes on the other side of the window using the other half of your template (this is why you marked 10.5″ from BOTH sides of the cardboard) you can proceed. If you hit any studs, skip to the next step. Otherwise, you will need to add anchors, which are typically provided with your curtain rod

Swap out your drill bit for the correct size that works with your anchors (ours needed a 3/16″ drill bit) and drill into each premade pilot hole to make larger holes for your anchors. Bonus – the template acts as a strong way to catch drywall dust!

With all of your anchor-ready holes drilled, gently tap in your anchors in with a hammer or mallet. If you are able to push your anchors into the wall by hand, you are making your holes too large! Switch to a smaller bit or keep your drill steadier as you drill. Loose anchors can cause your rod to sag or fall out of the wall over time.

Step 5. Install Your Curtain Brackets

The rest is fairly straightforward – hammer in your anchors and secure your curtain rod hooks to the wall using the provided screws. We do all of this in real-time in the video above if you want to see exactly how swift this whole things goes.

Step 6. Add Your Rod & Curtain Panels

With both brackets secured to the wall, you can hang your rod with your curtain panel already attached. Now you are done… unless your panels require any hemming. Or you could simply hide the bottoms behind a bed like we did below. Ha!

Bonus Pointer: Correct Any Rod Sagging

Depending on your rod and how wide it is, you may notice that it appears to sag a little bit in the middle – especially where the smaller rod piece connects into the larger ones. Your package may come with a third, center bracket to hang in the center of your window, but frequently a third brack would be overkill for any window that is not especially wide – so we rely on this weird little hack instead. Emphasis on WEIRD.

First, I take some of the protective plastic end caps that come on the curtain rods (they are simply packaging) and use a utility knife or scissors to cut off some small slices.

Then we tuck a piece inside the curtain rod at whatever connection point is sagging. It is essential that you put it on the TOP side of the rod and if you cannot slide it all the way in, simply rotate your rod slightly so it is hidden from view because no one is viewing your rod from the top.

I know it is TRULY weird, but it has been an straightforward way for us to correct a little bit of rod sag which makes my heart quite glad. Simply trust me – there is a noticeable difference and it no longer looks like it is sad and droopy. Plus it is free and I am scrappy. So yeah. Five stars, would recommend.

More Curtain Hanging Advice

And again, you can check out our pointers for hanging inexpensive white curtains and making them more pricey along the way.

If all of this still seems like too much trouble – you can get away with no curtains in your room too. We wrote a guide for when curtains do not belong in a room and what you can do to your windows instead. Spoiler: some rooms should not have window treatments at all!

P.S. Wanna know where we got something in our house (or what color’s on the walls)? Click here. And we made the same masterlist of sources & paint colors for the beach house too for ya. And we are pulling together a source lis for the duplex – it is not quite thorough yet, but a lot of the stuff we have there is on this page for ya – and there is more to come.

*This post contains affiliate links*